# How To Configure Gavika RADIUS On Aruba Operating System Software
**Aruba-NAS version: 6.5.4.10**
**Aruba-Type: 205**

Logon To Aruba
* username : Enter username
* password : Enter password

Click on `Security`

Ensure that you are in Authentication servers tab, click `New`.
Ensure that `radius` radio button is `selected`. Enter the following details:
* `Name` : Type any name of your choice.
* `IP address` : Type IP address of the radius server.
* `RadSec` : Ensure it is set to `disabled`.
* `Auth port` : Ensure it is set to `1812`.
* `Accounting port` : Ensure it is set to `1813`.
* `Shared key` : Choose a secure key.
* `Retype key` : Retype the shared key.
* `Timeout` : Ensure it is set to `5 sec`.
* `Retry count` : Ensure it is set to `3`.
* `RFC 3576` : Ensure it is set to `disabled`.
* `RFC 5997` : Ensure that both `Authentication and Accounting checked`.
* `NAS IP address` : Enter NAS IP address.
* `NAS Identifier` : Provide any name of your choice.
* `Dead time` : Ensure it is set to `5 mins`.
* `DRP IP` : Submit a blank value.
* `DRP Mask` : Submit a blank value.
* `DRP VLAN` : Submit a blank value.
* `DRP Gateway` : Submit a blank value.
* `Service type framed user` : click on `802.1x check-box`. Leave both `Captive Portal and MAC unchecked`.
click `OK`.


In the Networks, click `new`.
Under WLAN settings
* `Name` : Type any name of your choice.
* `Primary Usage` : Choose a category and click `Next`.

Under VLAN settings
* `Client IP assignment` : Ensure it is set to `Network assigned`.
* `Client VLAN assignment` : Ensure it is set to `default`.

Under Security settings
* `Security level` : Ensure it is set to `Enterprise`
* `Key management` : Ensure it is set to `WPA-2 Enterprise`
* `Authentication server 1` : choose the authentication server name that you created which is listed in the drop down.
* `Authentication server 2` : Submit a blank value.
* `EAP offload` : Ensure it is set to `disabled`.
* `Re-auth interval` :  set re-auth interval to `5min`.
* `Authentication survivability` : Ensure it is set to `disabled`.
* `MAC authentication` : Leave both the check-boxes `unchecked`.
* `Accounting` : Choose `Use separate servers` from the drop-down list.
* `Accounting server 1` : choose the accounting server that you created which is listed in the drop-down.
* `Accounting server 2` : Submit a blank value.
* `Accounting interval` : set accounting interval to `3 min`.
* `Blacklisting` : Ensure it is set to `disabled`.
* `Enforce DHCP` : Ensure it is set to `disabled`.

Under Fast roaming field
* `opt OKC and  802.11r`  
Click `Next`.

Under access settings
* `Access Rules` : Ensure it is set to `unrestricted`.
Click `Finish`.